Moteur de translation Caterpillar 227-6189 2276189 pour excavateur Caterpillar 330DL

330DL Final Drive for CAT Excavator spare parts 227‑6189 2276189 Axial Piston Motor OEM

Product Overview

On a big earthworks pad, the 330DL is the machine digging the load the smaller cats are hauling out — a 30‑ton long‑undercarriage excavator built for steady production rather than tight‑spot work. Its final drive, references 227‑6189 and 2276189, is the axial piston motor and planetary reducer tucked into each track frame that turns pump flow into the slow, heavy torque needed to drag that much steel across cut slopes and spoil piles. These CATs run long hours, and when the drive starts to tire, the whole shift feels it: one track lags on the climb back up the ramp, the track frame shell runs warm to the touch after a few truck cycles, and a new growl comes through the floor plates under load. Pushing on scores the piston block and valve plate, and the swarf that comes loose then wears the next set of parts for free. This OEM‑grade unit arrives as one complete, bench‑run assembly, so the worn drive lifts out whole and the replacement drops straight back into the original mounting.

Core Advantages

1. Torque to pull a loaded 30‑ton frame up ramps
Hardened gear stages multiply the motor's output down to sprocket speed, so the track digs in rather than spinning on muddy climbs. No laboured, whirring travel under load.

2. A lapped piston group that holds pressure
The cylinder block, shoes and valve plate are finished to tight running clearance, so oil pressure does not bleed internally. Both tracks pull in step — no wander, no lazy side, no hesitation when the bucket crowds the face.

3. Built for the dirt of big cut slopes
Long‑undercarriage machines work through mud, rock and standing water on mass‑earthmoving sites. Fresh shaft and housing seals keep that grit out of the lube and motor — the line between a drive that lasts and one that fails early.

4. One bolt‑in unit for a fast production turnaround
Motor and reducer arrive mated and test‑run. The fitter swaps the whole drive rather than building it on the floor, which matters when a parked 30‑ton machine is costing the production crew every hour.

5. OEM‑spec build without the dealer exchange price
Renewing the drive to original tolerances restores the 330DL's mobility at a fraction of an OEM exchange unit, with sample and batch supply for workshops keeping several D‑series cats running.

Manufacturing & Quality Control

Parts are machined to CAT drawing, heat‑treated at wear points, and assembled in a clean shop. Each finished drive spins on a hydraulic stand while torque, internal leakage and noise are logged; anything off the numbers comes apart for rework. Before crating, the internals are fogged with preservation oil, ports are plugged, and the unit sits on shock‑absorbing dunnage for sea and overland freight.

Frequently Asked Questions

Q1: How do I confirm 227‑6189 matches my 330DL?
A: Read the tag on your existing drive and send the machine serial number. CAT build variants across the D L series can differ, so we cross‑check before dispatch.

Q2: Does this include the sprocket?
A: The listing is the motor and reduction assembly. The sprocket typically transfers over; ask if yours is hooked and we will check a replacement.

Q3: What break‑in should the operator follow?
A: Take the first shift easy on loaded ramps. Light, cycling use seats the new gears and seals before the machine goes back to full truck loading.

Q4: What's excluded from cover?
A: Materials and build defects are covered. Dirty oil, debris in the motor, a stalled track forced into movement, overload or a botched install are not. Photograph any arrival damage before uncrating.